6pack
[Top] [All Lists]

Re: [6pack] Clutch/Transmission issue

To: "'John Mitchell'" <jmitch@snet.net>, <Darcy_Hunter@Instron.com>
Subject: Re: [6pack] Clutch/Transmission issue
From: "Bob Danielson" <75TR6@tr6.danielsonfamily.org>
Date: Wed, 27 May 2009 22:36:06 -0400
 John,
I did the same thing as you with the bolts. It worked great and guided the
tranny right in. You can see how here
http://tr6.danielsonfamily.org/5SpeedEngineInstall.htm


Bob Danielson
1975 TR6 CF38503U
Running w/ Throttle Body Injection
Toyota 5 Speed & Nissan LSD
http://tr6.danielsonfamily.org 

-----Original Message-----
From: 6pack-bounces@autox.team.net [mailto:6pack-bounces@autox.team.net] On
Behalf Of John Mitchell
Sent: Wednesday, May 27, 2009 8:38 PM
To: Darcy_Hunter@Instron.com
Cc: 6pack@autox.team.net
Subject: Re: [6pack] Clutch/Transmission issue

   The first time I installed my transmission,  I allowed the weight of the
transmission to hang briefly on the input shaft as I aligned things.  Big
mistake.  I caused the friction plate to get slightly bent and caused the
clutch to not disengage.  After that I used long(6") studs in the upper 3
holes across the top of the rear engine plate to hang the transmission on
while getting everything to slide together.  
Not sure that's your problem, but it's something to think about.  John
Mitchell  76 TR6  72 Stag

Hunter, Darcy wrote:
> No I did not Dale and in fact it was a bugger getting in until it 
> finally popped in place.  Do you think something could have come loose 
> but not showed up as a problem immediately?
>
> Darcy
>
>  
>
>   _____
>
> From: Dale [mailto:tpdwinch@yahoo.com]
> Sent: Tuesday, May 26, 2009 5:40 PM
> To: Hunter, Darcy; 6pack@autox.team.net
> Subject: Re: [6pack] Clutch/Transmission issue
>
>  
>
> Darcy
>
>  
>
> Just a question, did you use pilot bolts to support and direct the 
> transmission in place upon your last assembly?
>
>  
>
> Dale
>
>  
>
>   _____
>
> From: "Hunter, Darcy" <Darcy_Hunter@Instron.com>
> To: "6pack@autox.team.net" <6pack@autox.team.net>
> Sent: Tuesday, May 26, 2009 2:37:37 PM
> Subject: [6pack] Clutch/Transmission issue
>
> Thanks Kendall, I did go out to the garage last night and used a pry 
> bar to check the end float.  Did not use a mic but by feel, didn't 
> detect anything measureable so I'll put that in the column of reviewed but
not probable.
> Darcy
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack

http://www.team.net/archive

You are subscribed as 75tr6@tr6.danielsonfamily.org
_______________________________________________

Support Team.Net  http://www.team.net/donate.html

6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack

http://www.team.net/archive


<Prev in Thread] Current Thread [Next in Thread>