Mike:
If you have a digital camera, could you post some pictures of how your
mount
turns out? Might be useful for someone else in the future....
Vance
Vance Navarrette
Cogito Ergo Zoom
I think, therefore I go fast
-----Original Message-----
From: 6pack-bounces@autox.team.net [mailto:6pack-bounces@autox.team.net] On
Behalf Of Corbitt, Michael
Sent: Friday, February 20, 2009 7:55 AM
To: 6pack@autox.team.net
Subject: Re: [6pack] J-Type Overdrive - Measurement Needed
<snip>
Basically, I took measurements using my old gearbox extension (tail piece)
and
drive shaft and compared these to the configuration of the new overdrive set
up to determine that the height of the rubber bushing for the overdrive
mounting plate is the same as the height of the (1 =") gearbox mounting
bracket that is used with the 4 speed gearbox. How simple was that? In a
way
it seems it should have been a foregone conclusion, but not being real
mechanically inclined and without the original mounting bracket I didn't
know.
Now, if any of you later determine that I messed up my measurements and this
is not correct after all, I would appreciate the feedback.
Thanks again everybody.
Mike
Corvallis, OR
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|