You can view John's accelerator bushing photo by clicking on the following
link. The dimensions he used are as follows: ID .0380 Bushing OD is 0.670
, Bushing length 0.500 shoulder OD 0.900 shoulder length 0.250. Slit
lengthwise.
http://www.2simpleusa.com/triumphlist/Bush_HORTON.jpg
**************************************
Tony Gordon
72 TR6
**************************************
----- Original Message -----
From: johnehorton@yahoo.com
To: Tony Gordon
Sent: Saturday, January 17, 2009 9:16 PM
Subject: Re: [6pack] Picture
Coming your way. I installed this "kit' today from scratch. Took about 25
minutes and my ham hands had trouble getting the small Allen screws into the
collar. Sure tightened up the throttle. I took out the spring washer on the
passenger side because it is no longer needed. The setting is done by
positioning the collar to hold the bushing in the drivers side. Also the
cotter pin is not needed. John H.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|
