Ken,
There is a line of fasteners all along the top edge of the fender. You will
need to remove the inner trim to access those. There are not any on the B
post/dogleg like those you found under the front carpet kick panel.
Bob Clark
'69 TR6
--------------------------
Sent from my BlackBerry Wireless Handheld
----- Original Message -----
From: 6pack-bounces@autox.team.net <6pack-bounces@autox.team.net>
To: 6pack <6pack@autox.team.net>
Sent: Fri Jan 09 06:48:26 2009
Subject: [6pack] Advice on Removing Rear Panel
Hi all,
The Beast is a 1973 TR6, with J type OD, a tired cockpit, and some rust in
places, the worst being one rocker panel is pretty much rotted out.
After, oh, roughly 5 years or so of procrastination, I'm beginning the
repair to the rusted out driver's side rocker panel.
Got the front Panel off, wasn't easy, took a while, quite a while, to find
the bolts hidden behind the side carpeting.
Today and tomorrow I plan to remove the rear panel to fully expose the
rocker panel.
Plan of attack is -
Remove bumper /extension
remove Tail light housing
Remove the obvious bolts inside the trunk, underneath the panel bottom.
Now, based on the hidden bolts I found on the front, I'm sure there are
equivalents on the rear..
-are there hidden bolts way back under the body (can't think of the name)
back toward the cockpit area
-can I reach these thru the trunk
-must I remove the finishing trim in the cockpit area to get at any?
- any BTDT experience you can offer?
Thanks a Bunch
Ken
(a lurker),
Maricopa, Sonoran Desert, Arizona
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
You are subscribed as rclark@robertsonclark.com
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|