I finally finished converting my '69 gearbox to a J-type OD following
Nelson's articles and huge support from fellow member, Berry Price.
Following Nelson's article, I also replaced all seals and bearings. I
ran my first test last night. I can't begin to express the amount of
anxiety that built up right before I flipped the switch to turn the
electric motor on. It's almost like watching your first born come into
the world (don't tell me wife I said that) and checking all their
fingers and toes. Well, the gearbox sounded good. No grinding of
metal, clanking, etc. I only ran my test for about 5 minutes.
Nelson's article indicates I should have about 20 psi of residual
pressure in direct drive and 430-460 psi with the OD engaged. The gauge
I'm using registers from 0 - 600 psi in 10 psi increments. The gauge
registers very little, if any, residual pressure. With the OD engaged,
the needle bounces between 380 to 410 psi. I could definitely tell a
change in the speed of the input shaft when I engaged the OD, so I have
to believe it is working. Also, according to Nelson, there must be some
residual pressure; otherwise the dashpot would not work. Is the
engaged pressure acceptable? Is this lower than expected pressure
(380-410) and the movement of the needle indicating a problem, such as
with the pressure relief valve?
Any input would be appreciated.
Mike
Corvallis, OR
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|