Joe:
Sounds like you have lots of data saying that it is not an issue.
Personally, I always prefer data to a SWAG, which is what my comment was. I
was just wondering if it could be an issue. Aluminum rocker arms are a place
where I know this can really occur, although with computer aided stress
analysis, I think the newer designs are pretty sound. The old hot rod rule of
thumb was that aluminum rockers were only good for 50,000 miles.
Vance
Vance Navarrette
Cogito Ergo Zoom
I think, therefore I go fast
-----Original Message-----
From: N197TR4@cs.com [mailto:N197TR4@cs.com]
Sent: Tuesday, September 09, 2008 12:40 PM
To: Navarrette, Vance; John Cyganowski; "6pack@autox.team.net"
Subject: Re: [6pack] Aluminum Engine Plates
Vince and all.
I have not one report of any fatique failures on any of the alloy engine
plates, I manufacture, including the one I have run for about five years on
the front of my TR............. which is also the mounting points for the
engine.
Not that it cant happen...but if it does I will replace at no charge.
Joe Alexander
>From The Targa Newfoundland...well in a couple of days. :-)
> John:
>
> Don't forget about fatigue resistance. Aluminum has poor fatigue
life
>compared to steel. While the front engine plate is lightly stressed and
would
>be a good candidate for replacement, the rear plate is what melds the engine
>into a single unit. The front of the engine and the rear of the tranny are
>supported, but there is not support near the rear engine plate.
> I would worry about flex between the two components, and resulting
>cracks in the plate. I think to really answer that questions would require
>some stress analysis. Intuitively, it seems questionable as to the longevity
>of an identical rear plate fabricated from alloy. Just my $0.02.
>
> Vance
>
>
> Vance Navarrette
> Cogito Ergo Zoom
> I think, therefore I go fast
>
>-----Original Message-----
>From: 6pack-bounces+vance.navarrette=intel.com@autox.team.net
>[mailto:6pack-bounces+vance.navarrette=intel.com@autox.team.net] On Behalf
Of
>John Cyganowski
>Sent: Sunday, September 07, 2008 5:47 PM
>To: 6pack@autox.team.net
>Subject: [6pack] Aluminum Engine Plates
>
>Hi All-
>
>Looking for some thoughts on the aircraft grade aluminum engine plates? The
>front one and the Transmission support plate. Are these strong enough?
>
>John Cyg
>_______________________________________________
>
>Support Team.Net http://www.team.net/donate.html
>
>6pack@autox.team.net
>http://autox.team.net/mailman/listinfo/6pack
>
>http://www.team.net/archive
>
>You are subscribed as n197tr4@cs.com
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|