Dave, the dash support will easily accommodate a standard DIN cage. The
structural nature of the H support is vastly overrated. Expanding the existing
hole slightly for the DIN cage will have no ill effects beyond deducting a few
concourse points.
Stan
-----Original Message-----
From: 6pack-bounces+stan.foster=hp.com@autox.team.net
[mailto:6pack-bounces+stan.foster=hp.com@autox.team.net] On Behalf Of David
Friedlander
Sent: Wednesday, September 03, 2008 8:20 PM
To: 6 Pack
Subject: [6pack] Radio Install prep
Hi all!
I was thinking of going out to buy a new stereo radio for my car. The
stock opening in
my dash support plinth measures 1-3/4 x 4-1/2". Most standard radio
cases today
measure about 2-1/4 x 7-1/4". Is it safe to cut out that much material
from the plinth
or is some reinforcement needed/recommended?
Dave
'74-Six
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|