6pack
[Top] [All Lists]

Re: [6pack] Cylinder head removal

To: <6pack@autox.team.net>
Subject: Re: [6pack] Cylinder head removal
From: "David A. Schenck" <davidaschenck@comcast.net>
Date: Sat, 28 Jun 2008 21:17:28 -0400
I got the head off the car.  It took some patience to get the studs out and
then I was able to whack it with a rubber hammer and it popped right off.
My next step is pull one of the intake valves and check it.  What is the
easiest way to remove the valve springs.  Bentley and Haynes say to use a
valve spring compressor.  Where do I get one of these?  Any tips or tricks
to be aware of?

Thanks,

Dave

TR250
'78 Spitfire
Towson, MD

-----Original Message-----
From: lfm614@aol.com [mailto:lfm614@aol.com]
Sent: Saturday, June 28, 2008 6:55 PM
To: davidaschenck@comcast.net
Subject: Re: [6pack] Cylinder head removal

I used the rope trick on mine.  You stuff as much 1/4" nylon rope in
cylinders 1 & 6 and turn the crank with a pipe wrench or put the car in a
high gear and roll it a bit.   It will try to compress the rope which of
course it can't do and break the head loose.

Lou
------Original Message------
From: davidaschenck@comcast.net
Sender: 6pack-bounces+lfm614=aol.com@autox.team.net
To: TR-6 list
ReplyTo: davidaschenck@comcast.net
Sent: Jun 28, 2008 3:23 PM
Subject: [6pack] Cylinder head removal

I am having trouble removing the cylinder head on my TR250.  I think part of
it may be that I was only able to get out about 1/3rd of the studs and that
removing all of them would make it easier.

Any advice or tricks for removing the studs and the cylinder head itself
would be greatly appreciated.

Thanks,

Dave Schenck

TR250
78 Spitfire
Towson, MD

Sent from my Verizon Wireless BlackBerry
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack

http://www.team.net/archive

You are subscribed as lfm614@aol.com
_______________________________________________

Support Team.Net  http://www.team.net/donate.html

6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack

http://www.team.net/archive


<Prev in Thread] Current Thread [Next in Thread>