[6pack] Distributor new, but 28 degs in timing ?

[richard olson <nosto53@yahoo.com>]

I am trying to put my new dist in. (Jeff@AdvancedDistributors)
  I tested my 'old' dist (points and condenser) and my ign timing was 10deg. 
BTDC
   
  I took my old dist and pinch bolt out.
  Then I put the new dist at the same was the drive dog. (I think?). 
  Put the new in ('Ignitor' Pertronix).
   
  New cap and rotor, new red/black wires.  Start car OK, 900rpm
  BUT... 3-4 mins, the RPM gone up to 2500rpm?
   
  I was testing the timing gun and the ign was 28deg?
  But went I used to old one - the deg was OK.
   
  Do I have a explanation for this?
  I am confusion.
  Is my drive dog OK - not in 180?
   
  RickO
  '72 TR6
_______________________________________________

Support Team.Net  http://www.team.net/donate.html

6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack

http://www.team.net/archive