Todd:
FYI, it is easy to make your own. I thought TRF prices were more
than a little high.
Bought some 16ga weld plate from the hardware store for a few
dollars, made a cardboard template from the actual diff mount, then
transferred it to the weld plate. Cut the plates using a hacksaw, used a
grinder to smooth the edges. Welded them in. Success!
Admittedly, the TRF plates are nicely made, and VERY robust.
However, not many people will be looking at my home made plates, and
they will probably out last me.
Cheers,
Vance
-----Original Message-----
From: 6pack-bounces+vance.navarrette=intel.com@autox.team.net
[mailto:6pack-bounces+vance.navarrette=intel.com@autox.team.net] On
Behalf Of Todd Bermudez
Sent: Wednesday, February 06, 2008 10:32 AM
To: Bob Danielson; 'list Triumph'; 6pack@autox.team.net
Subject: Re: [6pack] Differential Mount Repair
Hi Bob,
Mine went inside. I took the template off vtr & had
some fabricated....I would say you'd want them "just"
a bit smaller than the mount
Cheers,
Todd
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|