Tom,
I don't want to give you my measurements since the car I have here has
had the inners replaced. I did want to tell you how much I like the work
you are doing. Keep at it, it looks great! I personally really like the
Damson on a TR6. Looks very sexy when all done.
Jim Franks (I'm a pilot with a British car obsession, too!)
Tomislav Marincic wrote:
> Hello,
>
> I need to install the 4 rubber wedges that keep the hood/bonnett from rubbing
>against the inner fenders when it's down. The problem is that I replaced the
>tops of my inner fenders, so the holes are gone. I'd like to position them as
>close as possible to the original location.
>
> Could someone please take a moment and measure the location of the center of
>their bonnet buffers from a reference point, such as the cowl panel or the
>bonnet support cones? I notice there's a raised boss stamped in one place
>toward the aft side of the inner fenders; does one set of buffers go on this?
>Finally, does the flat bottom side of the buffers go all the way down against
>the fenders, or are they "raised" to some degree?
>
> Thanks again, Tom
> CC55483L
>
> http://www.triumphowners.com/735
> _______________________________________________
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|