That units fits the TR6 well. It installs easily (in seconds) and is short
enough that you can move it forward or further back depending on your
preference. I found if I had it too far forward I kept banging my elbow when
changing gear so I have it pushed back and I enhanced it with a cup holder,
power outlets and a satellite radio receiver.
Pictures at:
Cup holder closed:
http://i38.photobucket.com/albums/e119/foster461/TR6/JCW%20Armrest/cupholderc
losed.jpg
Cup holder Open:
http://i38.photobucket.com/albums/e119/foster461/TR6/JCW%20Armrest/cupholdero
pen.jpg
Power and Satellite:
http://i38.photobucket.com/albums/e119/foster461/TR6/JCW%20Armrest/DSCN0998.j
pg
I have one outlet permanently hot, the other is switched from the ignition.
The seats are Miata in case anyone is confused.
I have since read that the center console from a mid 90's Camry will fit once
you cut the front section off which also yields a nice slim metal two-cup
cupholder that could be installed under the passenger dash. I bought one on
eBay for under $20 although I haven't had a chance to mess with it due to
other projects but it also looks like it will fit.
Stan
-----Original Message-----
From: owner-6pack@Autox.Team.Net [mailto:owner-6pack@Autox.Team.Net] On Behalf
Of Joe Laurito
Sent: Sunday, December 09, 2007 3:53 PM
To: 'John VanNorman'; '6-Pack'
Subject: RE: [6pack] arm rest
John;
I'm going to let you in on the world's best kept secret. Go to
www.jcwhitney.com and search on zx135858a. It fits like an OEM part and you
don't have to pay $150.
NFI
Joe Laurito
Central PA Triumph Club
|