George---As you probably figured, it's more important to move the engine
back, as it is up. Holding the engine's position are the two front
mounts and the rear mount (at the transmission tail) It's possible that
the one at the rear may be keeping the engine from shifting back, but
these rubber mounts are usually pretty flexible.
Exhaust pipes aren't typically mounted in a rigid fashion, but it may be
worth looking under the car to be sure this nothing's welded firmly to
the frame.
The front mounts are slotted at an angle, so you'll want to position
these in a way that lets the engine go back the farthest. When you have
done this, there should be around 9/16 inch of clearance between the
belt pulley and the cross tube and the steering rack.
Altho you shouldn't have to do this, you could loosen the four (u-bolt)
nuts that hold the steering rack in place and lever it forward, just
enough to slip the belt in.
Dick
From:
George_Loriot@Brown.edu(Loriot, George)
Hi Listers,
Don't want to be a pest but I'm still having problems with the fan belt
clearance on my 76 TR6 (1/2" fan belt doesn't clear steering rack). As
you folks have noted correctly, the front engione mounts were sagging,
particularly the right side, so I got new ones (TRF "no-sag") and am
installing them. Still have problems, what am I doing wrong?
Everyone says to loosen ther mounts and jack up the engfie. So I did
that,...
George Loriot
|