Rebuilding the carbs...
anyone know which aluminum spacer washer to use for the jet in the float
bowl?
there are many sizes. two of which are thicker and i know ONE of them is to
be used...
but not sure if the very thickest one or the second to thickest one. i read
16mm, but
i don't have an tool to measure at precision and they are both so close.
Also, does a gasket go under the spacer? or just the spacer itself? diagrams
only
show the spacer.
one other question, i didn't want to mess with taking the trim idle screw
out...does that get a fresh
gasket under it? i didn't see anything in the instructions, but honestly i
just glanced.
thanks!
james
76 tr6
_________________________________________________________________
More photos, more messages, more storageget 2GB with Windows Live Hotmail.
http://imagine-windowslive.com/hotmail/?locale=en-us&ocid=TXT_TAGHM_migration_HM_mini_2G_0507
|