Thanks Chuck, all good advice.
R. Ashford Little II
6-PACK Membership Secretary
<http://www.ralittle2.com/> '70 TR6
From: Chuck Arnold [mailto:triosan@gmail.com]
Sent: Wednesday, May 02, 2007 6:55 PM
To: R. Ashford Little II
Cc: 6pack; Triumph Email List
Subject: Re: [6pack] TR6 driveshaft removal?
Lossen the two bolts on the motor mounts [not the ones on the engine
directly]. Undo the drive shaft bolts on both ends. Remove the tranny
tunnel. Remove the two nuts on the tranny mount that hold the mount to the
tranny. Put a jack under the tranny and jack it up as high as you can [may
need to manipulate the tranny mount]. This should get the tranny high
enough that the drive shaft can come out below it. Been there, done that.
This is all from [relatively recent] memory.
|