On Mon, 17 Jul 2006, John & Allison Cyganowski wrote:
> Changing out my u-joints. They seem very dry. Anyway, I am having trouble
> with clearance. The existing u-joints have raised sections on one side.
> These are on the flat part in the center of the joint diagonally across from
> each other. Then pressing the caps out, the joint impacts the back of the
> yoke and in come cases leaves a mark in the metal of the yoke. Very often the
> caps are still inbedded in the joint/yoke. Any advice?
BIG CHANNEL LOCK PLIERS will help work the caps out.
I haven't found a better way.
> John Cyg.
regards,
rml
------------------------------------------------------------------------------
Bob Lang Room N42-140Q | This space for rent
Consultant MIT unix-linux-help |
Voice:617-253-7438 FAX: 617-258-9535 | Cell: xxx-xxx-xxxx
------------------------------------------------------------------------------
|