6pack
[Top] [All Lists]

TR6 Manifold Gasket Query

To: 6pack@autox.team.net
Subject: TR6 Manifold Gasket Query
From: "Robert M. Lang" <lang@isis.mit.edu>
Date: Tue, 2 May 2006 10:14:41 -0400 (EDT)
Hi,

I recall seeing this on the list recently, but I can't recall how it
resolved... can anyone confirm that Moss PN 695-030 is the thick black
composite manifold gasket?

I'm having probs getting my header to seal after milling the head, so I'm
going to try doubling up the gasket in case the header flange is fouling
on the block because of the milling job. This is a 12:1 motor - the head
is severely milled (if that matters).

But I've had really good luck with the black composite gaskets in the past
and I want to make sure that this is what PN 695-030 is. Note: this is an
early federal spec head.

regards,
rml
------------------------------------------------------------------------------
Bob Lang              Room N42-140Q            |  This space for rent
Consultant            MIT unix-linux-help      |
Voice:617-253-7438    FAX: 617-258-9535        |  Cell: xxx-xxx-xxxx
------------------------------------------------------------------------------




<Prev in Thread] Current Thread [Next in Thread>