6pack
[Top] [All Lists]

Re: GoodParts Compression ratio

To: "Robert M. Lang" <lang@isis.mit.edu>
Subject: Re: GoodParts Compression ratio
From: Shannon Muncy <shannon.muncy@gmail.com>
Date: Tue, 9 Aug 2005 15:15:59 -0400
You're correct about 93 octane being sometimes hard to find.  I carry
a few cans of octane booster... just in case.  But it hasn't been a
problem yet.

-Shannon

> 
> Assuming that by 91+ you mean 91+ RON + MON / 2 (what pumps are supposed
> to display in the US), then I would have to say that you need 93 octane
> fuel and you'd have to retard the ignition. 94 octane Sunoco (or other
> brand) might work...
> 
> I would not run an iron motor over 10:1 without knowing the exact fuel
> octane and whether the motor will knock under load.
> 
> Call me cheap, but I don't like holes in the pistons and broken rings...
> and that's what happens if your motor experiences detonation.
> 
> A lot of folks with high compression motors run av-gas or racing fuel to
> insure that there is no detonation.
> 
> From asking around other TR6 owners with "pumped up motors", I'd have to
> say that going much above 9.5:1 is iffy if you drive because it's not
> unusual to pull up to a gas pump in Backwater, USA only to discover that
> your only choice is regular 87 fuel. Been there, done that. With 9.5:1,
> you have a prayer (that the merchant has some octane booster on the
> shelf). With a higher C/R, you're asking for trouble.
> 
> On my 9.5:1 car, I've tried a tank of 89 octane pump fuel and experienced
> "run-on" when the motor is hot. When I use the 93 octane pump fuel, I
> don't get any run-on. I wouldn't think of putting 87 octane in there.
> 
> > Michael K CD255L, etc....
> 
> regards,
> rml
> CF14111U and CR1871UO
> ------------------------------------------------------------------------------
> Bob Lang              Room N42-140Q            |  This space for rent
> Consultant            MIT unix-linux-help      |
> Voice:617-253-7438    FAX: 617-258-9535        |  Cell: xxx-xxx-xxxx
> ------------------------------------------------------------------------------




<Prev in Thread] Current Thread [Next in Thread>