On Fri, 5 Aug 2005, Shannon Muncy wrote:
> Listers,
>
> OK.. I've given up on my Lucas dizzy and I've ordered a Malory Unilite
> distriubutor to replace it. I read that the drive dog needs to be
> drilled, does anyone know specifically what needs to be done to fit
> the old drive dog to the new dizzy?
First off, welcome to the fold. Lucas dizzy's mean frustrationor at least
have been for me. I gave up after almost 30 years of Lucas frustration and
swapped in the Mallory dizzys.
The new dizzy comes with some instructions. In short, you figure out how
you want the thing oriented, you slide the drive dog on and makr the
location. Then you have to set the end-float to some number then you drill
and install the dog and pin - then you're done.
It's a 20 minute job for a competent machinist.
> I plan to use www.gaugeguys.com to convert my tach to an electronic unit.
Good choice.
> Thanks for any help/advice,
> -Shannon
> 1972 Triumph TR6 CC80068
regards,
rml
------------------------------------------------------------------------------
Bob Lang Room N42-140Q | This space for rent
Consultant MIT unix-linux-help |
Voice:617-253-7438 FAX: 617-258-9535 | Cell: 339-927-4489
Note to subscribers: Please e-mail to unix-linux-help@Mit.edu so that all the
consultants see your message. This will ensure a more timely response. Thanks.
------------------------------------------------------------------------------
|