Ron,
>Question #1: It appears that there are two gaskets for the front engine plate
>included in the Payen Top End gasket kit. >One appears to be unimpregnated
>brown paper gasket and the other is an impregnated gray gasket. My instinct is
>to >use the gray gasket alone but why would two be supplied with the Payen kit?
I believe that there was a first design and second design for the front plate
gasket. Use the same gasket that was removed.
>Question #2: There are two gaskets that came in top end kit that are
>approximately 2 3/4" square with holes in the >corners that I can't seem to
>place on the engine. They may be for the carbs but I thought four are needed
>for the >carbs? They are pink-colored as shown in the attached link.
>http://home.comcast.net/~ronald.weber/MAIN.HTML
yes, this is one of the carb gaskets
>Question #3: The lower end gasket set included a brown gasket 1 7/16" x 3 1/4"
>that I also can't place on the engine. >It is also shown in the attached
>image.
I believe that this gasket may be the oil pump gasket. My memory might fail me
on this one.
>Ron
>71TR6
Take Care,
Greg Perry
|