Adam---I'm not sure if I understand your question.
What I know works for the TR6 is the Bosch 02 sensor, part # 11027. It
has one white wire that must be connected to the white wire from the
monitor. The monitor should have both a red and black wire. Red is the
hot, (connected to the "geen" fusebox junction, which is controlled by
the ign. switch) and black goes to ground.
You can either make your own monitor, or if this doesn't appeal to you,
buy the whole package from K&N. The part number for non-computor
controlled vehicles is 85-2441 for the complete kit.
For those engines that still must pass emissions testing, and may be,
er, modified, having the monitor will give you a real-time reading on
what's going out the tailpipe. Tune accordingly.
Dick
From: adam@adambeasley.com(Adam C Beasley) Date: Thu, Mar 3, 2005,
10:51am (PST+3) To: tr6taylor@webtv.net ('Sally or Dick Taylor'),
6pack@autox.team.net Subject: RE: Air-Fuel Monitor
Do you know if I can buy an O2 sensor for a ford or chevy, cut the
connector of, and wire it into a gauge?
Thanks,
Adam
|