6pack
[Top] [All Lists]

Re: Spring height TR250 TR6

To: 6-Pack <6pack@Autox.Team.Net>,
Subject: Re: Spring height TR250 TR6
From: Don Malling <dmallin@attglobal.net>
Date: Sat, 29 Jan 2005 08:38:03 -0500
Thanks to all who replied. Especially Ted Schumacher.

I am now convinced my rear springs have sagged. The list members tell me stock 
height on fronts are 
10.2 and rears are 11.5. My old fronts are 10.2 but my old rears are 10.75.

I also noticed that there are more coils per inch on the rears than on the 
fronts. The same is true 
for the new 20% upgrade springs. According to Dick Taylor, more coils per inch 
(with same wire size) 
means that the rears are weaker springs than the fronts, so I suppose it's 
reasonable that they 
sagged and the fronts didn't.

The 20% upgrades are about .7" shorter than stock which is I guess is 
reasonable because they are 
stiffer springs. Seems they should start out shorter to maintain the stock road 
height under load.

Thanks again to all who responded.


Don Malling


Don Malling wrote:
> Does anyone know where/how I can determine or find the unloaded height 
> of the stock front and rear springs for a TR250 or TR6.
> 
> I have purchased a set of new 20% uprated springs for my TR250. The 
> fronts are the same height as my original stock front springs but the 
> rears are taller than my originals. Seems funny to me. The vendor has 
> suggested that my rears have sagged, which I kind'a doubt, or at least 
> wonder about.
> 
> At any rate, if I could check the height of my original rear springs, I 
> would like to.
> 
> Seems to me I checked in Bentley and it wasn't there.
> 
> Thanks,
> 
> Don Malling




<Prev in Thread] Current Thread [Next in Thread>