Thanks
I had kind of figured that was the case so it is nice to
have ones assumptions validated.
Gary Oehrle
Office Phone 408-501-6896
Cell Phone 408-718-1175
-----Original Message-----
From: Sally or Dick Taylor [mailto:tr6taylor@webtv.net]
Sent: Friday, August 13, 2004 12:08 AM
To: Oehrle Gary (IFNA COM)
Cc: 6pack@autox.team.net
Subject: RE: Chapter 3 on TR6 Transmission--Reverse gear grinder
Gary---Two of the bolts that connect the bell housing to the engine
backplate should be 3/8 inch diameter, the same as the two dowels
supplied with the Gunst kit. If you use them in their designated holes,
they'll serve the same purpose, and preserve the factory concentricity
between the throwout bearing and the clutch diaphragm fingers.
Dick
Check out the new British Cars Forum:
http://www.team.net/the-local/tiki-view_forum.php?forumId=8
|