I purchased my 1976 TR6 only a few months ago. It had undergone a frame off
resto a couple/few years earlier but was limited to the frame, body and
interior. No mechanicals. Because of 5/16-3/8" wide upper door gaps I laid
under the car for most of an hour checking frame details and it looked great.
The po had jobbed this work out. Because of a number of uneven gaps I
concluded that they were just sloppy on a lot off finish details. I have since
realigned most. So far in my short ownership the door gaps don't seem to have
changed. I want to tighten them up a bit but after looking thru the many books
and catalogs I have it's not real clear to me where all the rear mount point
are that I must loosen and shim. I know that I read this can be done but can't
remember where. Can anybody out there who has done this enlighten me?
Thanks, Steve
|