Replace one of the transmission cover bolts with the one provided.
Gunst's instructions show the one to replace look for Schraube 1/4 x 1"
UNF in his instructions at this web page
http://www.buckeyetriumphs.org/technical/Clutch/ReliableClutch/ReliableClutch.htm
There is a picture of the completed installation here -- at the bottom
-- last picture on the page
http://www.buckeyetriumphs.org/technical/Clutch/ReliableClutch/ReliableClutch.htm
In this picture Nelson replaced the metal strap with a turnbuckle.
The spring keeps the bearing in constant contact with the pressure plate
fingers.
Don Malling
John Mitchell wrote:
> Hi again everyone, for the life of me I can't figure out where to
> attach the metal strap that the preload spring attaches to. Diagram
> with the directions just doesnt make sense to me. Which bolt do I
> replace and where. Is the spring supposed to keep the TO bearing
> pressed against the clutch fingers or away from them. I really need
> help on this one. Thanks in Advance
>
> John Mitchell 76TR6 now with Overdrive
|