You need to have a pinkie that is just the right size. I slide my pinkie
into the hole on the top of the dog and just ease it up. It is just a
friction fit between my finger and the dog, but works just fine. Remember
that it will rotate as it moves up the shaft.
Peter
'68 TR250 (c-c-cold here in the NE)
on 12/19/03 2:37 PM, R. Ashford Little II at ralittle2@mindspring.com wrote:
> The larger question is that I need to rotate the distributor drive dog or
> spindle assembly to properly position the distributor, but I'm having a
> difficult time grasping the spindle. I've tried using a cheap slide hammer
> and pull from Harbor Freight, actually two, but the puller is made of
> aluminum and tends to bend when I try to get a tight grasp. So how do the
> esteemed list members perform this task?
|