Ed,
If you've not gotten the specific answer to your question here it is, along
with Triumph part number for the primary fastener:
1. Transmission to trans mount: 1/2 x 1-1/2 UNF hex bolt (HB1112) qty 2 with
lock washers and nuts
2. Clutch slave cylinder to bracket: 5/16 x 1-1/8 UNF hex bolt (HB809) qty 2
with lock washers and nuts (if 1-1/8 long not found go to 1-1/4 long)
3. Clutch slave bracket to engine: 5/16 x 1-5/8 UNF hex bolt (HB813) qty 2 with
lock washers and nuts
4. Trans bellhousing to engine: 5/16 x 1-3/8 UNF hex bolt (HB811) qty 8 with 11
lock washers and nuts (extra for 3 studs from block)
I might be wrong on this but to be on the safe side all fasteners in this case
must be Grade 8 hardware. Try to avoid the hardware superstores like Lowes and
Home Depot.
Greg
CD6250L
>
>
> From: bratt <bratt@sasktel.net>
> Reply-To: bratt <bratt@sasktel.net>
> To: 6pack@autox.team.net
> Subject: Transmission bolts
> Date: Sat, 20 Sep 2003 11:19:00 -0600
>
> I finally received my transmission for my 1976 TR6, now I need bolts to put
> it in.
>
> Does anyone know the quantity, thread, sizes, and lenghts of bolts I need
> for the bellhousing, slave cylinder and rear mounts?
>
> Thanks.
>
> Ed
>
> _________________________________________________________________
|