When I get my Rimmer 6-into-one stainless header back from Jet Hot,
I plan on using the SLP193 header gasket I got from TRF. I've no
idea if that's a "beefed-up" enough gasket .... Anyone know a better
part number and source for a no-leaks header gasket, before I bolt this
one together?
Dave Friedlander
CF25194UO
Peter Macholdt wrote:
> Gene,
>
> Did you use a heavy duty header gasket? I'm not sure that it is possible to
> get a good seal without a beefed-up gasket. That's what I used on my Rimmer
> header and, no leaks.
>
> Peter
> '68 TR250
>
> on 5/3/03 5:47 PM, Gene Holtzclaw at motrv8d@hotmail.com wrote:
>
> > I've just put a header on from Rimmer Bros. It is the stainless 2 piece 3 to
> > 1 headers. They leak at the head. Any suggestions from those who've been
> > there done that?
> >
> >
> >
> >
> >
> > _________________________________________________________________
> > Add photos to your messages with MSN 8. Get 2 months FREE*.
|