I was told by a TR6'er over here that part of my carb problems may be the
fact that I am using gross jets instead of the original needle jets.
Okay I bought. I ordered and received today two new needle jets which I
immediately placed in the carbs.
Problem is now one of my carbs seems to be leaking from the lower screw hole
of the cold start valve??? I can't really figure out why the screw hole
would go all the way into the carb and allow gas to escape though it?
The floats are set at 16mm at the highest point as suggested on the buckeye
site but I'm assuming that too much gas is getting into the float bowl.
Any suggestions?
Thanks,
Mark Bullard
|