I've seen this done well only 2 ways.
1. Remove body from frame.
2. Cut an access panel thru the shelf area.
I was hoping someone had a better solution.
YMMV
Jim
----- Original Message -----
From: "Ronald A. Dowty" <rdowty@dowtyenterprises.com>
To: <6pack@autox.team.net>
Sent: Monday, November 11, 2002 4:20 PM
Subject: Welding advice
> I'm sending this message out again since I only got one respose and I'd
> like to hear from someone who's been-there-done-that before.
>
> I've got to replace the forward differential support on my frame which
> is off the car. The old bracket appears to have been welded to the stud,
> then the stud was welded to the cross member. Since I don't want to cut
> the stud out and it's a tight fit for my mig what should I do or have
> done to get a good weld on the bracket to stud joint?
|