Steve---The trim piece with the molded door pull is glued on with
contact cement.
The fuzzy molding is U-shaped where it fits over the sheet metal between
the A and B post.
The door waist seal is held on to the door sheet metal with barbed
clips. They can be a bit tricky to get them all connected with the door
in tact. Everyone who has done this usually has to 'invent' their own
tool to hold the clip, while slipping the seal down into the door. The
one I use is difficult to describe, but Berry's isn't. If he's looking
in, maybe he'll share it with us again.
Dick
'73
|