| To: | hurls@world.std.com (Jim Hurley) |
|---|---|
| Subject: | re: Mazda pistons |
| From: | tr6taylor@webtv.net (Sally or Dick Taylor) |
| Date: | Fri, 5 Apr 2002 22:52:06 -0800 (PST) |
Jim---I don't think the TR6 block will allow being bored out to 2700 c.c.'s. This would mean a piston size of 3.055, or .115 over stock. (Using the stock stroke.) The piston sets I found to cost upwards of $1000 were forged, rather than cast alum. Dick |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: TR6 Oil Gallery Plug Unavailable, bob |
|---|---|
| Next by Date: | Re: TR6 Oil Gallery Plug Unavailable, Sally or Dick Taylor |
| Previous by Thread: | Stebro Exhaust, nick gemas |
| Next by Thread: | Re: Mazda pistons, Kai M. Radicke |
| Indexes: | [Date] [Thread] [Top] [All Lists] |