Thanks to all who offered advice about the color to finish my rotors. They
are now a bright aluminum (powder coat) with new pistons and seals, including
the little seal between the two halves (Moss #583-820).
New question: What is the specification for the minimum rotor thickness? I
found a runout spec of .002" max in an old Haynes manual that also says the
maximum that can be removed is .060" but they don't specify the thickness when
new or the thickness when new minus .060 inches.
TEA
Nelson Riedel
Granville, Ohio
'68TR250, '76TR6, '70TR6 (project)
|