Steve:
I installed new accelerator shaft bushings last fall. I ended up having to
cut a pie shaped wedge out of each one. They are just too large to fit in
the hole along with the shaft. I heated them in a cup of water in the
microwave and removed just a small bit at a time in order to not make them
too small.
They will still fit tightly so don't use any glue. You may not be able to
remove them later. Good luck!
Walt Fogle
'69 TR6
Woodinville, WA
To All,
>
>I have purchased bushings for the accelerator shaft on my TR6 that are
>placed
>on each end of the shaft as it exits then reenters the fire wall.
>
>I cannot get them seated in the hole. I am about to cut of one side and
>glue
>them in. Any ideas?
>
>Steve Janny
>San Antonio TX
>74 TR6
>75 Spitfire
_________________________________________________________________
Chat with friends online, try MSN Messenger: http://messenger.msn.com
|