Hello List:
I picked up my '69 TR6 from the motor shop yesterday after the engine
rebuild. Yee-ha! What a difference! It just pulls and pulls.
I have a small problem, however. The bonnet needs to be realigned. For
comparison, can someone (or maybe a couple of responses would be great, too)
tell me your measurements, say, between the top inner fender EDGES around
where the 4 rubber bumpers screw into each fender? I'm measuring about 47
1/4" (rear of engine bay) and 45 7/16" (front of engine bay). These were
taken at the top of each rubber bumper, sheet metal to sheet metal on each
side. I hope I've conveyed this well.
Thanks for any kind attention.
Best regards,
Walt Fogle
'69 TR6, CC30689L
Woodinville, WA
_________________________________________________________________
|