You can rotate the adapter piece a few degrees so that rather than the
filter hanging straight down, it tilts a slight bit. This should allow
you to clear the slave cylinder.
Tim Holbrook
1971 TR6
--- Fred Wickline <BriickBea@worldnet.att.net> wrote:
> Listers,
> I am having trouble fitting a new spin-on oil adapter to my 74
> TR6.
> The adapter mounts up OK but when I try to install the filter it hits
> the
> clutch slave cylinder. Has anybody had a similar problem? If so
> what do I
> do to get the filter on? Thanks Wick
>
__________________________________________________
|