Re: 6 Pack Digest V1 #174

[tr6taylor@webtv.net (Sally or Dick Taylor)]

Ellvet---The major TR6 parts suppliers carry undersized bearings for
both rods and mains, and come in sizes of .010, .020, and .030.  If your
crank has been ground before, the size stamped on the back of the
bearings will show this.
A good automotive machine shop can easily do this regrinding. Expect to
pay about $65 for this service, plus the cost of the bearings. Some
shops like to know the stroke of the crank beforehand, which is 3.74. It
should then be as good as a "new" crank.

Dick T.
'73