I was getting ready to put the metering unit back in and noticed that the
drive shaft (for it - the
metering unit - and the oil pump that runs off the camshaft) has some
'rotating' play between the cam gear and the centre shaft, is this OK?? I
thought it could be for backlash but I hauled out a spare and there's no
movement. There's a pin going through the gear to hold it on, that might
have broken in the middle. It will spin both ways around 5mm.
Any ideas????
Regards
DaveW
///
/// 2000-register@autox.team.net mailing list
///
|