PI intake set-up

["Dave W" <dw_triumph@clear.net.nz>]

Hi everyone, just a quick note. Since the last email I got an exhaust maker
to shape the pipes to replace the rubber ones, but the tool the guy used put
crimps in the pipe which messed up the diameter. So today I tried another
shop that does mandrel bends, out the back the guy had a whole load of scrap
90-degree bends in stainless!! now all that's needed is to cut all the
angles out and hope they fit!!!!

Dave W

///
///  2000-register@autox.team.net mailing list
///